Follow these tips to make your custom sign look polished and professional:

• Use large fonts with contrasting colors to increase readability
• If you're using arrows on your inserts, double check to make sure they'll face the right way in the frame
• Go with high-resolution images you can enlarge without visible blurring
• Put sand or water inside the frame to weigh it down (instructions included)

The main difference between them is how the inserts are mounted onto the sign:

Deluxe Signicade® frames feature built-in tabs and slots that securely hold signs in place without additional tools or adhesives.

Standard Signicade® frames require 2" x 2" hook-and-loop fasteners (included with frame) or screws (not included) to attach signs.

Both frame types come in black or white.

There are 3 methods you can use to install the inserts: using the hook-and-loop fastenters included with your frame or using different types of screws (not included). Please see instructions below:

Option 1: Hook-and-loop fasteners (Recommended)

• Clean the sign surface and the back of the insert with rubbing alcohol.
• Use 8 (4 per side) 2” x 2” hook-and-loop Industrial Strength Fasteners.
• Apply the rough (male) side to the frame corners, let the adhesive cure for 15 minutes, then attach the sign.
• These are included with your Signicade® sign.

Option 2: Screws

• Use 8” x 1” sheet metal screws to attach the sign through the frame (4 per side). No pre-drilling required.
• These are not included with your sign but can be found at a local hardware store.

Option 3: Well Nuts & Screws

• Drill four 15/32” holes in the frame, 2 ¼” from each corner.
• Insert well nuts, align with ¼” holes drilled in the sign, and secure with ¼”-20 x 1” machine screws.
• These are not included with your sign but can be found at a local hardware store.

To install the insert into your deluxe Signicade® frame, please follow these steps:

1. Slide the insert down through the side tabs.
2. Pull the insert down in front of the bottom slot until it touches the ground.
3. Push the top of the insert into the upper slot.
4. Slide the insert fully into the bottom slot.

The Protective Glossy Coating is an optional finish applied to corrugated plastic inserts. It provides a scratch-resistant, high-gloss surface that enhances durability and gives your sign a professional, polished look. You’ll be able to add this option to your Signicade® at checkout.

Yes it is. The standard frame comes with 6 pre-cut, adhesive-backed hook-and-loop fasteners. Just remove the backing and place 3 on both the frame and the insert. The deluxe frame inserts fit perfectly in the recessed sign areas and the tabs hold your graphics firmly in place, without damaging them. You can easily remove your inserts just by sliding them up and out.

You can do both. For just the inserts, select the “1 Insert (No Frame)” bundle option at the top of the page. We sell the deluxe Signicade® frame option separately as well.

They’re made of corrugated plastic – the same material as our yard signs.

We have a 3-business day shipping option so you can get your custom Signicade® sign in time for your event or business need.

Yes we do. For a popular indoor option, check out our metal A-frames. They’ve got a polished, professional look, with paper poster inserts. For a more classic look, check out our chalkboard signs.

Yes it does. Just unbox, fill up the frame base with water or sand and you’re good to go.

Our plastic Signicade® deluxe has caps on each side. To add sand or water, simply remove the cap, fill the hole, then put the cap back on. We recommend using no more than 10 lb. of sand.